Brocade Multi-Service IronWare Switching Configuration Gui Instrukcja Użytkownika Pobierz pdf (Strona 596)

100

101

566 Multi-Service IronWare Switching Configuration Guide

53-1003036-02

Displaying VSRP 2

This display shows the following information when you use the vrid num or vlan vlan-id parameter.

For information about the display when you use the aware parameter, refer to “Displaying the active

interfaces for a VRID”.

TABLE 69 CLI display of VSRP VRID or VLAN information

This field... Displays...

Total number of VSRP

routers defined

The total number of VRIDs configured on this device.

VLAN The VLAN on which VSRP is configured.

auth-type The authentication type in effect on the ports in the VSRP VLAN.

VRID parameters

VRID The VRID for which the following information is displayed.

state This device’s VSRP state for the VRID. The state can be one of the following:

• initialize – VSRP is not enabled on the VRID. If the state remains

“initialize” after you enable VSRP on the VRID, make sure that the VRID is

also configured on the other routers Routing Switches and that the

routers Routing Switches can communicate with each other.

NOTE: If the state is “initialize” and the mode is incomplete, make sure you

have specified the IP address for the VRID.

• standby – This device is a Backup for the VRID.

• master – This device is the Master for the VRID.

Administrative-status The administrative status of the VRID. The administrative status can be one of

the following:

• disabled – The VRID is configured on the interface but VSRP or VRRP-E

has not been activated on the interface.

• enabled – VSRP has been activated on the interface.

Advertise-backup Whether the device is enabled to send VSRP Hello messages when it is a

Backup. This field can have one of the following values:

• disabled – The device does not send Hello messages when it is a Backup.

• enabled – The device does send Hello messages when it is a Backup.

Preempt-mode Whether the device can be pre-empted by a device with a higher VSRP priority

after this device becomes the Master. This field can have one of the following

values:

• disabled – The device cannot be pre-empted.

• enabled – The device can be pre-empted.

NOTE: For the following fields:

• Configured – indicates the parameter value configured on this device.

• Current – indicates the parameter value received from the Master.

• Unit – indicates the formula used tor calculating the VSRP priority and the timer scales in effect for the

VSRP timers. A timer’s true value is the value listed in the Configured or Current field divided by the

scale value.

priority The device’s preferability for becoming the Master for the VRID. During

negotiation, the Backup with the highest priority becomes the Master.

If two or more Backups are tied with the highest priority, the Backup interface

with the highest IP address becomes the Master for the VRID.

hello-interval The number of seconds between Hello messages from the Master to the

Backups for a given VRID.

1 2 ... 591 592 593 594 595 596 597 598 599 600 601 ... 983 984

Komentarze do niniejszej Instrukcji

Brak uwag

Brocade Multi-Service IronWare Switching Configuration Gui Instrukcja Użytkownika Strona 596

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria komputerowe Brocade Multi-Service IronWare Switching Configuration Gui