Brocade Multi-Service IronWare Routing Configuration Guide Instrukcja Użytkownika Pobierz pdf (Strona 427)

100

101

Multi-Service IronWare Routing Configuration Guide 399

53-1003033-02

Configuring a global management VRF

SCP

SCP uses SSH as underlying transport. The behavior of SCP is similar to the SSH server. For more

information, refer to “SSH server” on page 397.

Syslog

When the management VRF is configured, the Syslog module sends log messages only through the

ports belonging to the management VRF and the out-of-band management port.

Any change in the management VRF configuration will be immediately effective for Syslog.

NOTE

The Syslog source interface configuration command ip syslog source-interface must be compatible

with the management VRF configuration. Refer to “Source interface and management VRF

compatibility” on page 396.

Configuring a global management VRF

To configure a VRF as a global management VRF, enter the following command.

Brocade(config)# management-vrf mvrf

Syntax: [no] management-vrf vrf-name

The vrf-name parameter specifies the name of the pre-configured VRF. If the VRF is not

pre-configured, the command execution fails and displays the following error message.

Error - VRF <vrf-name> doesn't exist

When the management VRF is configured, the software generates the following Syslog message.

SYSLOG: VRF <vrf-name> has been configured as management-vrf

Enter the no form of the command to remove the management VRF. When the management VRF is

deleted, the software generates the following Syslog message.

SYSLOG: VRF <vrf-name> has been un-configured as management-vrf

Configuration notes

Consider the following configuration notes:

• If there is a management VRF already configured, you must remove the existing management

VRF configuration before configuring a new one. If not, the system displays the following error

message.

Brocade(config)# management-vrf red

Error - VRF mvrf already configured as management-vrf

• If you try to delete a management VRF that was not configured, the system displays the

following error message.

Brocade(config)# no management-vrf red

Error - VRF red is not the current management-vrf

1 2 ... 422 423 424 425 426 427 428 429 430 431 432 ... 845 846

Komentarze do niniejszej Instrukcji

Brak uwag

Brocade Multi-Service IronWare Routing Configuration Guide Instrukcja Użytkownika Strona 427

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria komputerowe Brocade Multi-Service IronWare Routing Configuration Guide