Brocade Multi-Service IronWare Routing Configuration Guide Instrukcja Użytkownika Pobierz pdf (Strona 328)

100

101

300 Multi-Service IronWare Routing Configuration Guide

53-1003033-02

Displaying IPv4 IS-IS information

Level-2 Hello Multiplier The number by which the software multiplies the hello interval to

calculate the hold time set for Level-2 Hello PDUs sent on this circuit.

This parameter is not displayed for interfaces that are configured with a

Point-to-Point circuit type. This is because separate Level-2 Hello

messages are not sent on Point-to-Point interfaces. Consequently, "Hello

Interval", "Hello Multiplier", and "Authentication" parameters should

always be configured in the Level-1 mode for Point-to-Point interfaces.

Level-2 Designated IS The NET of the Level-2 Designated IS.

Level-2 DIS Changes The number of times the NET of the Level-2 Designated IS has changed.

Next IS-IS LAN Level-1 Hello Number of seconds before next Level-1 Hello PDU will be transmitted by

the Brocadedevice.

Next IS-IS LAN Level-2 Hello Number of seconds before next Level-2 Hello PDU will be transmitted by

the Brocade device.

Number of active Level-1 adjacencies The number of ISs with which this interface has an active Level-1

adjacency.

Number of active Level-2 adjacencies The number of ISs with which this interface has an active Level-2

adjacency.

Circuit State Changes The number of times the state of the circuit has changed.

Circuit State Adjacencies Changes The number of times an adjacency has started or ended on this circuit.

Rejected Adjacencies The number of adjacency attempts by other ISs rejected by the Brocade

device.

Circuit Authentication L1 failures The number of times the Brocade device rejected a circuit because the

authentication did not match the authentication configured for

Level-1on the Brocade device.

Circuit Authentication L2 failures The number of times the Brocade device rejected a circuit because the

authentication did not match the authentication configured for Level-2

on the Brocade device.

This parameter is not displayed for interfaces that are configured with a

Point-to-Point circuit type. This is because separate Level-2 Hello

messages are not sent on Point-to-Point interfaces. Consequently, "Hello

Interval", "Hello Multiplier", and "Authentication" parameters should

always be configured in the Level-1 mode for Point-to-Point interfaces.

Bad LSP The number of times the interface received a bad LSP from an IS at the

other end of the circuit. The following conditions can cause an LSP to be

bad:

• Invalid checksum

• Invalid length

• Invalid lifetime value

Control Messages Sent The number of IS-IS control PDUs sent on this interface.

Control Messages Received The number of IS-IS control PDUs received on this interface.

Hello Padding: The Hello Padding configuration, which can be:

• Enabled

• Disabled

IP Enabled If set to TRUE, the IP protocol is enabled for this circuit.

IP Address and Subnet Mask The IP address and subnet mask for this interface.

TABLE 42 IS-IS interface information (Continued)

This field... Displays...

1 2 ... 323 324 325 326 327 328 329 330 331 332 333 ... 845 846

Komentarze do niniejszej Instrukcji

Brak uwag

Brocade Multi-Service IronWare Routing Configuration Guide Instrukcja Użytkownika Strona 328

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria komputerowe Brocade Multi-Service IronWare Routing Configuration Guide