Brocade Multi-Service IronWare Routing Configuration Guide Instrukcja Użytkownika Pobierz pdf (Strona 250)

100

101

222 Multi-Service IronWare Routing Configuration Guide

53-1003033-02

Displaying OSPF information

Displaying OSPF interface information

To display OSPF interface information, enter the following command at any CLI level

If you specify an interface that is not configured within a specified VRF, then the following error

message will display as shown in the example below:

Brocade# show ip ospf vrf one interface ethernet 1/1

Error: Interface(eth 1/1) not part of VRF(one)

NOTE

You cannot display multiple ports for any interfaces. For example, when displaying OSPF interface

information on ethernet 1/1 only one port can displayed at a given time.

Syntax: show ip ospf [ vrf vrf-name] interface [ip-addr] [brief] [ ethernet port | loopback number |

tunnel number | ve number ]

The [ vrf vrf-name] parameter displays information for VRF, or a specific vrf-name.

The [ip-addr] parameter displays the OSPF interface information for the specified IP address.

The [brief] parameter displays interface information in the brief mode. Refer to “Displaying OSPF

interface brief information” on page 224.

The ethernet | loopback | tunnel | ve parameter specifies the interface for which to display

information. If you specify an Ethernet interface, you can also specify the port number associated

with the interface. If you specify a loopback, tunnel, or VE interface, you can also specify the

number associated with the interface.

The following table defines the highlighted fields shown in the above example output of the show ip

ospf interface ethernet command.

TABLE 26 Output of the show ip ospf interface command

This field Displays

Interface The type of interface type and the port number or number of the interface.

IP Address The IP address of the interface.

Area The OSPF area configured on the interface

Brocade# show ip ospf interface ethernet 1/11

Ethernet 1/11 admin up, oper up

IP Address 10.1.1.15, Area 0

Database Filter: Not Configured

State active(default passive), Pri 1, Cost 1, Options 2,Type broadcast

Events 2

Timers(sec): Transmit 1, Retrans 5, Hello 10, Dead 40

DR: Router ID 192.168.254.1 Interface Address 10.1.1.1

BDR: Router ID 10.0.0.15 Interface Address 10.1.1.15

Neighbor Count = 1, Adjacent Neighbor Count= 1

Neighbor: 10.1.1.1 (DR)

Authentication-Key: None

MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 845 846

Komentarze do niniejszej Instrukcji

Brak uwag

Brocade Multi-Service IronWare Routing Configuration Guide Instrukcja Użytkownika Strona 250

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria komputerowe Brocade Multi-Service IronWare Routing Configuration Guide