56 Network OS Command Reference
53-1003115-01
bridge-priority
2
bridge-priority
Specifies the priority of the bridge.
Synopsis bridge-priority priority
no bridge-priority
Operands priority Specifies the bridge priority. Valid values range from 0 through 61440 in
increments of 4096.
Defaults Priority is 32768.
Command Modes Protocol Spanning Tree mode
Description Use this command to set the bridge priority for the common instance. Using a lower priority value
indicates that the bridge might become root.
Usage Guidelines This command must be used to specify the priority of the bridge. The priority values can be set only
in increments of 4096.
If xSTP is enabled over VCS, this command must be executed on all RBridge nodes.
Enter no bridge-priority to return to the default priority.
Examples To specify the bridge priority:
switch# configure terminal
switch(config)# protocol spanning-tree stp
switch(conf-stp)# bridge-priority 8192
switch# configure terminal
switch(config)# protocol spanning-tree rstp
switch(conf-rstp)# bridge-priority 8192
switch# configure terminal
switch(config)# protocol spanning-tree mstp
switch(conf-mstp)# bridge-priority 8192
See Also protocol spanning-tree
Komentarze do niniejszej Instrukcji