Brocade Multi-Service IronWare Multicast Configuration Gui Instrukcja Użytkownika Pobierz pdf (Strona 193)

Multi-Service IronWare Multicast Configuration Guide 181

53-1003032-02

PIM Anycast RP

NOTE

The PIM Anycast CLI applies to only PIM routers running RP. All deny statements in the

anycast_rp_set ACL are ignored.

The example shown in Figure 20 is a PIM Anycast-enabled network with three RPs and one PIM-FH

router connecting to its active source and local receiver. Loopback 2 in RP1, RP2, and RP3 each

have the same IP addresses 1001:1. Loopback 3 in RP1, RP2, and RP3 each have separate IP

address configured to communicate with their peers in the Anycast RP set.

FIGURE 20 Example of a PIM Anycast RP network

Displaying information for an IPv6 PIM Anycast RP interface

To display information for an IPv6 PIM Anycast RP interface, enter the show ipv6 pim anycast-rp

command.

Syntax: show ipv6 pim [vrf vrf-name] anycast-rp

The vrf parameter allows you to display information for an IPv6 Anycast RP interface for the VRF

instance identified by the vrf-name variable.

Table 44 describes the parameters of the show ipv6 pim anycast-rp command.

TABLE 44 Output from the show ipv6 pim anycast-rp command

Field Description

Number of Anycast RP Specifies the number of Anycast RP sets in the multicast domain.

Anycast RP Specifies a shared RP address used among multiple PIM routers.

ACL ID Specifies the ACL ID assigned.

ACL Name Specifies the name of the Anycast RP set.

ACL Filter Specifies the ACL filter state SET or UNSET.

Peer List Specifies host addresses that are permitted in the Anycast RP set.

Brocade(config)# show ipv6 pim anycast-rp

Number of Anycast RP: 1

Anycast RP: 1001::1

ACL ID: 200

ACL Name: my-anycast-rp-set

ACL Filter: SET

Peer List:

1:1:1::1

2:2:2::2

3:3:3::3

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 215 216

Brak uwag

Brocade Multi-Service IronWare Multicast Configuration Gui Instrukcja Użytkownika Strona 193