Brocade Mobility Access Point System Reference Guide (Supp Instrukcja Użytkownika Pobierz pdf (Strona 373)

100

101

Brocade Mobility Access Point System Reference Guide 363

53-1003100-01

6. Select + Add Row to define the following for critical resource configurations:

7. Select the Monitor Interval tab.

FIGURE 201 Device Overrides - Critical Resources screen - Monitor Interval tab

8. Set the duration between two successive pings from the access point to critical resource.

Define this value in seconds from 5 - 86,400. The default setting is 30 seconds.

IP Address

Provide the IP address of the critical resource. This is the address used by the access point to ensure the

critical resource is available. Up to four addresses can be defined.

Mode

Set the ping mode used when the availability of a critical resource is validated. Select from:

• arp-only – Use the Address Resolution Protocol (ARP) for only pinging the critical resource. ARP is used to

resolve hardware addresses when only the network layer address is known.

• arp-and-ping – Use both ARP and Internet Control Message Protocol (ICMP) for pinging the critical

resource and sending control messages (device not reachable, requested service not available, etc.).

Port

Provide the port on which the critical resource is available. Use the spinner control to set the port number.

VLAN

Define the VLAN on which the critical resource is available using the spinner control.

1 2 ... 368 369 370 371 372 373 374 375 376 377 378 ... 853 854

Komentarze do niniejszej Instrukcji

Brak uwag

Brocade Mobility Access Point System Reference Guide (Supp Instrukcja Użytkownika Strona 373

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria komputerowe Brocade Mobility Access Point System Reference Guide (Supp