Brocade FastIron Ethernet Switch Layer 3 Routing Configura Instrukcja Użytkownika Pobierz pdf (Strona 156)

100

101

The distancenum parameter configures the administrative distance for the route. You can specify a

value from 1 - 255. The default is 1. The value 255 makes the route unusable.

The last three parameters are optional and do not affect the null route, unless you configure the

administrative distance to be 255. In this case, the route is not used and the traffic might be forwarded

instead of dropped.

Static route next hop resolution

This feature enables the Brocade device to use routes from a specified protocol to resolve a

configured static route. By default this is disabled.

To configure static route next hop resolution with OSPF routes, use the following command.

device(config)# ip route next-hop ospf

Syntax: [no] ip route next-hop [ /jointfilesconvert/1441084/bgp | ospf | rip ]

NOTE

This command can be independently applied on a per-VRF basis.

This command causes the resolution of static route next hop using routes learned from one of the

following protocols:

• /jointfilesconvert/1441084/bgp - both iBGP and eBGP routes are used to resolve static routes.

• ospf

• rip

NOTE

Connected routes are always used to resolve static routes.

Static route recursive lookup

This feature enables the Brocade device to use static routes to resolve another static route. The

recursive static route next hop lookup level can be configured. By default, this feature is disabled.

To configure static route next hop recursive lookup by other static routes, use the following command.

device(config)# ip route next-hop-recursion 5

Syntax: [no] ip route next-hop-recursion level

The level available specifies the numbers of level of recursion allowed. Acceptable values are 1-10.

The default value is 3.

NOTE

This command can be independently applied on a per-VRF basis.

Static route resolve by default route

This feature enables the Brocade device to use the default route (0.0.0.0/0) to resolve a static route.

By default, this feature is disabled.

Static route next hop resolution

156 FastIron Ethernet Switch Layer 3 Routing Configuration Guide

53-1003087-04

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 671 672

Komentarze do niniejszej Instrukcji

Brak uwag

Brocade FastIron Ethernet Switch Layer 3 Routing Configura Instrukcja Użytkownika Strona 156

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria komputerowe Brocade FastIron Ethernet Switch Layer 3 Routing Configura