Brocade Fabric OS Message Reference (Supporting Fabric OS Instrukcja Użytkownika Pobierz pdf (Strona 39)

Fabric OS Message Reference 17

53-1003140-01

Displaying system message logs and attributes

Enabling a RASLog message or module

To enable a single RASLog message or all messages in a module that were previously disabled,

perform the following steps.

1. Log in to the switch as admin.

2. Use the following commands to enable a single RASLog message or all messages that belong

to a module:

• Execute the rasadmin --enable -log messgae_ID command to enable a single RASLog

message that has been disabled.

For example, execute the following command to enable BL-1001 message that was

previously disabled.

switch:admin> rasadmin --enable -log BL-1001

2012/10/15-13:24:30, [LOG-1006], 373, SLOT 4 | CHASSIS, INFO, switch, Log

message BL-1001 has been enabled.

Use the rasadmin --show -log messgae_ID command to verify the status of the message.

• Execute the rasadmin --enable -module module_ID command to enable all messages in a

module. For example, execute the following command to enable to all previously disabled

BL messages.

switch:admin> rasadmin --enable -module BL

2012/10/15-13:28:37, [LOG-1007], 375, SLOT 4 | CHASSIS, INFO, switch, Log

Module BL has been enabled.

Use the rasadmin --show -module module_ID command to verify the status of the

messages that belong to a module.

Setting the severity level of a RASLog message

To change the default severity level of a RASLog message, perform the following steps.

1. Log in to the switch as admin.

2. Use the rasadmin --set -log message_ID -severity [DEFAULT | INFO | WARNING | ERROR |

CRITICAL] to change the severity level of a message. For example, execute the following

command to change the severity level of C2-1004 message to WARNING.

switch:admin> rasadmin --set -log C2-1004 -severity WARNING

3. Use the rasadmin --show -severity message_ID command to verify the severity of the message.

switch:admin> rasadmin --show -severity C2-1004

Message Severity

C2-1004 : WARNING

Displaying system message logs and attributes

This section provides information on displaying the system message logs. These procedures are

valid for all the supported platforms.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 99 100

Brak uwag

Brocade Fabric OS Message Reference (Supporting Fabric OS Instrukcja Użytkownika Strona 39