Brocade Fabric OS Encryption Administrator’s Guide Support Instrukcja Użytkownika Pobierz pdf (Strona 124)

104 Fabric OS Encryption Administrator’s Guide (DPM)

53-1002922-01

Rekeying all disk LUNs manually

Viewing the progress of manual rekey operations

To monitor the progress of manual rekey operations, complete these steps:

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to Figure 6 on page 14.)

2. Select an encryption group from the Encryption Center Devices table, then select Group >

Re-Key Sessions from the menu task bar.

The Re-Key Sessions Status dialog box displays, which enables you to check on the status of

each LUN that is being rekeyed within an encryption group. (Refer to Figure 78.)

FIGURE 78 Re-Key Sessions Status dialog box

The dialog box contains the following information:

• LUN #: The LUN number.

• LUN Serial #: The LUN serial number.

• Re-Key Session #: The number assigned to the rekeying session.

• Percent Complete: The percentage of completion of the rekeying session.

• Re-Key State: Options are:

- Re-Key Setup

- LUN Prep

- LUN Clean-up

- Key Update

- Read Phase

- Write Phase

- HA Sync Phase

• Re-Key Role: Options are:

- Primary/Active

- Backup/Active

• Block Size: The block size used on the LUN.

• Container Name: The CryptoTarget container name.

• Host Port WWN: The WWN of the host port that is being used for the write operation.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 331 332

Brak uwag

Brocade Fabric OS Encryption Administrator’s Guide Support Instrukcja Użytkownika Strona 124